Mig-29 SLIDE ON GROUND at 24" span

This is the MPF version, 24" span Mig29
It's a Full One sheeter
This model is similar to many of my other offerings.
Like the F-15, F-14, F-22, SU-34 and Pak50
All can do Slide ON Ground Take off or
or a gentle underhand toss with get em in the air too
Free plans are here

Mig 29 $25


F-22 for Slide ON Ground
F-22 info

F-22 Slide On Ground 28.5" span
This is Otto's Giant F22 scaled down to fit on one sheet
Now Made exclusively with MPF.
It's a simple One Sheeter but out of MPF.

F22 $25


F-15 for Slide ON Ground
F-15 info

F-15 Slide On Ground 28.5" span
This is the one that started my Slide On Ground fun
Now Made exclusively with MPF.
Parts set include extra Nose, Fin and elevon parts.
Plus whatever MPF scrap is left over from the Two Sheet Cutting
See pdf plans for details

F15 $34.50


Mid sized Mig-29 SLIDE ON GROUND

This 36" span Mig29 is cut from MPF
Jack Steinhauser has built a Nice example
from the 1st shippment
See pic at Left
It is cut from 2 FULL sheets of MPF
and includes 4 Ply horns.
This is the build article on rcg
Here is a vid
Vid done with a low end Turnigy DVR
clipped to glasses
Slight centering issue and lower rez
than DVR was advertised for
Here is NEWER a vid

Mig 29 $55


F-15 SOG Now made with MPF 36" span

F-15 Slide On Ground 36" span
This is a larger version and uses 2 full sheets of MPF
I use a single6mm sq CF spar and Packing tape decoration.
You can use either strong packing tape or Slick stuff on the bottom.
Here is a vid

$50


F22 SOG now made with MPF 38" span

F22 Slide On Ground 38" span
This is a larger version and uses 2 full sheets of MPF
It is a bit more difficult to build due to the sloped Fuse sides and angled Fins You can use either strong packing tape or Slick stuff on the bottom.
Here is a vid

$50


A Full Sized Reliable Trainer in FOAM

Falclone56 is a Foamy version
of an old time favorite Trainer
Designed and built to use made in USA MPF foam.
Much more info at RCGroups in this thread
Free plans are here
Maiden vid here
Foam parts from 2 full 2'x4' sheets of MPF
Plus 3mm depron sheeting for wing covering.
Includes 1/32" ply doublers and 1/4" motor mount
This is not a traditional foamy. It is built like a balsa model.
However, Slot and Tab parts insure good alignment

$57.50

SU-47 Forward Swept Wing
more info


Order WHITE Here ! - $32

Bobzcat 24" span now made with MPF
A simple typicaly configured Cat type Pusher

Order in White only ! $16.50

PterraCat 24" span
more info

Order WHITE Here ! - $23

HOME
Indiana State weather
Aviation Weather
Custom Info
About Us
Shipping
Contact us
E-mail me at bob@hoosiercutoutservice.com
Created by HCS admin - all rights reserved - Nov 2013